Therm-X Supplies & Replacement Parts

Protect a $6,000 machine on the road. The Therm-X AT is built to travel — 14 lbs with a carry handle. This case is what makes that practical: a padded, purpose-fit shell for the unit and its hose, so the machine survives the bus, the baggage hold, and the back of a truck. Purpose-fit for the Therm-X AT control unit Room for the umbilical hose so the whole setup travels together Made for road games and home visits — or just moving between treatment rooms without carrying the unit bare Cheaper than one repair. A cracked housing or bent fitting costs more than the case

Read more less

Three-piece extender kit so your one-size garments actually fit everyone. Therm-X garments are one-size-fits-most — but "most" isn't everyone. This kit adds reach to the shoulder, hip, and back garments so larger patients and bigger athletes get the same correct, even compression as everyone else. Three straps covering the garments most likely to run short Keeps compression even — an over-stretched garment loses contact and treats unevenly Commercial-grade hook-and-loop matched to the garment closures Worth keeping on hand if you treat linemen, heavyweight athletes, or a general adult population Works with the Therm-X AT durable garment line.

Read more less

Run two garments from one Therm-X unit. The split umbilical hose divides a single control unit's output across two garments — so one machine can treat both knees after a bilateral procedure, cover a shoulder and an elbow in one session, or serve two athletes back-to-back without swapping lines. Doubles the throughput of a single control unit — usually cheaper than a second machine Self-sealing quick-connect fittings at both garment ends, so detaching one side doesn't drain the system Compatible with the Therm-X AT and the full Therm-X garment range

Read more less

Hospital-grade power supply for the Therm-X AT. Many hospitals, ambulatory surgery centers and inpatient rehab facilities require hospital-grade power connections for any equipment used in a patient-care area. If your facility's biomedical engineering department has that standard, this is the power supply your Therm-X needs to pass inspection. Hospital-grade rated for patient-care environments Direct manufacturer part for the Therm-X AT Check with your biomed department before ordering — if they require hospital-grade, the standard supply will be rejected at intake

Read more less

Genuine Therm-X coolant, 1 quart. The consumable that keeps your unit running. Therm-X units run on a distilled water and isopropyl alcohol coolant mix rather than ice. This is the manufacturer's replacement fluid, formulated to hold the unit's rated temperature range without the corrosion or residue that off-spec substitutes leave in the pump and lines. 1 quart — compatible with the Therm-X AT and Therm-X HOME Protects the pump and radiator — using the wrong fluid is the fastest way to a service call Keep a spare on the shelf. A treatment room with an empty tank is a treatment room out of service Ordering for a clinic or training room? Ask us about case pricing.

Read more less

Genuine standard replacement power supply for the Therm-X AT. Direct manufacturer part for units in clinics, training rooms and home settings that do not require the hospital-grade version. Standard-grade — for non-patient-care environments Direct manufacturer replacement for the Therm-X AT Need hospital-grade instead? See the Therm-X Hospital-Grade Power Supply

Read more less

Genuine single-connector umbilical hose for the Therm-X AT. The hose is the part that gets stepped on, rolled over by a cart, and yanked when a patient shifts. It is the most common wear item on any circulating therapy system. Single-garment connector with self-sealing quick-connect fitting Direct manufacturer replacement — no adapters, no fit guessing Worth keeping a spare. A failed hose puts a $6,000 machine out of service over a $226 part

Read more less